Prosperative Public Forum

Spinning Cogs

0 Members and 1 Guest are viewing this topic.

Spinning Cogs
« on: April 02, 2018, 01:16:39 AM »
Jack1936

Offline Jonathan Leger

  • *****
  • 8863
  • Here's to your success!
    • View Profile
    • Jonathan Leger's Blog
Re: Spinning Cogs
« Reply #1 on: April 02, 2018, 03:43:27 AM »
Try now Jack.

Re: Spinning Cogs
« Reply #2 on: April 02, 2018, 05:30:21 AM »
Sorry, no luck Jon - I am simply trying to put a pause (comma) after the word "or" either on slide 3 of the first project version or slide 4 on the second project version.
While writing could you also comment on whether it is possible to back out from the spinning cogs within the programme instead of closing the programme down and re-booting as I do now?
Jack1936

Offline Jonathan Leger

  • *****
  • 8863
  • Here's to your success!
    • View Profile
    • Jonathan Leger's Blog
Re: Spinning Cogs
« Reply #3 on: April 02, 2018, 07:14:40 AM »
It's not something you can back out of. I'm aware of the cause and I'm working on a solution.

For the moment it should run fine, but there's one particular command set that's throwing a wrench in the system. It only happens under a certain set of circumstances for a certain kind of video. I'm working on fixing that so things remain consistent.

Jon

Offline Jonathan Leger

  • *****
  • 8863
  • Here's to your success!
    • View Profile
    • Jonathan Leger's Blog
Re: Spinning Cogs
« Reply #4 on: April 02, 2018, 09:05:05 AM »
Ok, I think I figured out what the issue was. Let me know if it happens again.